Pin layout of 2000 Explorer TPS?

MalcolmV8 · Post by **MalcolmV8** » Mon Feb 21, 2005 11:57 pm

I'm trying to connect the TPS connector from the explorer harness to the 90 Mustang injector harness I have. The wires are different colors. Does anyone know which is positive, negative, and signal wire on the TPS? How about on the IAC?

I don't want to purchase the Explorer wiring diagrams just for those two connectors.

Thanks
Malcolm

cjcnomor4 · Post by **cjcnomor4** » Tue Feb 22, 2005 8:42 am

the red wire on the iac is from eec power, the white/blue is the pcm controlled ground. the ground is switched on and off real fast to duty cycle the solenoid. at the tp brown/white is vref (5v), grey/white is tp input(signal), and grey/red is signal return(sensor ground). wire colors for the mustang are the same for the iac, the tp is as follows: orange/white to brown/white, dark green/light green to gry/white, black/white to grey/red. hope this helps.

MalcolmV8 · Post by **MalcolmV8** » Tue Feb 22, 2005 9:04 am

Thanks so much. I'm going to wire that up tonight when I get home. I'll let you know how it goes. I'm making good progress so far.

MalcolmV8 · Post by **MalcolmV8** » Wed Feb 23, 2005 12:39 pm

I checked the wires on the TPS early this morning and they matched the colors you gave me. I should be good on that.

Thanks