So where do you go from here?

Posted by cgrey8 from dialup-4.154.84.103.Dial1.Atlanta1.Level3.net (4.154.84.103) on Wednesday, December 01, 2004 at 6:20PM :

In Reply to: They say it's normal. posted by Malcolm [Boardmaster] on Tuesday, November 30, 2004 at 3:51PM :

Registered Ranger

It sure sounded like in the MPG that you make of the 5th gears, that THAT was the noise you were getting at running speeds. However the noise was coming from the front, not the rear.

Back to square 1? Or do you have any other ideas and findings that have given you new direction?

At least you eliminated my pilot theory. Often researching a problem, you eliminate the possibilities and see what's left. I'm curious to know what this ends up being...

Unfortunately, when it comes to the innerds of a tranny, I'm pretty useless. I've never done any major tranny work to speak of. The only tranny work I have done is replace the input shaft that knocked a tooth off. The truck it was in was an F150 with a 300 I-6 w/single barrel. No torque to speak of so luckily it didn't damage the mating gear.

Chris

Automated Logic Follow Ups: Re: So where do you go from here? - Malcolm 9:59PM 12/01/2004 (4) Re: So where do you go from here? - seantx 2:06AM 12/02/2004 (1) Re: So where do you go from here? - Malcolm 2:58AM 12/02/2004 (0) Re: So where do you go from here? - cgrey8 2:06AM 12/02/2004 (1) Re: So where do you go from here? - Malcolm 3:16AM 12/02/2004 (0) Post a Followup Name: E-Mail: ( default ) Subject: Message: : It sure sounded like in the MPG that you make of the 5th gears, that THAT was the noise you were getting at running speeds. However the noise was coming from the front, not the rear. : Back to square 1? Or do you have any other ideas and findings that have given you new direction? : At least you eliminated my pilot theory. Often researching a problem, you eliminate the possibilities and see what's left. I'm curious to know what this ends up being... : Unfortunately, when it comes to the innerds of a tranny, I'm pretty useless. I've never done any major tranny work to speak of. The only tranny work I have done is replace the input shaft that knocked a tooth off. The truck it was in was an F150 with a 300 I-6 w/single barrel. No torque to speak of so luckily it didn't damage the mating gear. : Chris Optional Link ( default ) URL: Title: Optional Image Link ( default ) URL: